Get Started; Insert The Remote Control Batteries; Find The Correct Viewing Channel - Philips HTS3180 User Manual

4 Get started

Insert the remote control
batteries
1
Slide the battery cover off the back of the
remote control.
2
Insert the 2 supplied batteries (AAA). Be
sure the + and - ends of the batteries line
up with the markings inside the case.
3
Slide the cover back into position.
Note
•
Do not mix batteries (old and new or carbon
and alkaline, etc.).
• Remove batteries if they are exhausted or if
the remote control is not to be used for a long
time.
•
Batteries contain chemical substances, they
should be disposed of properly.
Control a play source
1
Press RADIO, USB or DISC button to
select the source you wish to control.
2
Select the desired function (for example
, ).
Downloaded From TheatreSystem-Manual.com Manuals
Navigate through the menu
1
Point the remote control directly at the
remote sensor on the product and select
the desired function.
2
Press the following buttons on the
remote control to navigate through the
on-screen menus.
Button
OK
Find the correct viewing
channel
1
Press to turn on this product.
2
Press DISC to switch to disc mode.
3
Turn on the TV and switch to the correct
video-in channel in one of the following
ways:
• Go to the lowest channel on your
TV, then press the Channel Down
button until you see the Philips
screen.
• Press SOURCE button repeatedly
on the remote control of your TV.
Action
Move up or down
Move left or right
Confi rm a selection
Enter numbers
EN 13