Advertisement
19. Remove the two brackets from the copier (two
screws each).
Note:
The four screws removed here will be used to
install the image controller.
<Attaching the image controller to C652 in all
regions and C552/C452 in regions that utilize 127 to
240V power>
* When attaching the image controller to C552/
C452 in regions that utilize 110 to 120V power,
follow the step 20 in page E-6 and later.
20. Remove the connector cover from the rear lower
side of the copier. The connector cover is shown
by the arrow in the illustration below.
21. Connect the supplied power cord (for connection
between copier and IC) to the connector.
22. Insert the harness into the wire saddle.
23. Fix the end of the ground wire included in the
A0YEIXC044DA
24. Install the image controller on the copier (four
Note:
A0YEIXE036DA
Power cord
A0YEIXE051DA
E-5
power cord (for connection between copier and
IC) to the copier (screw furnished with the video
interface kit).
screws).
Be sure to use the four screws removed in step
19.
Threaded hole
Wire saddle
A0YEIXE052DA
A0YEIXE053DA
A0YEIXE038DB
Advertisement
