Advertisement
VII. Checking the setup with a test print
After setting up the image controller, print the config-
uration sheet to check that the controller is operating
correctly.
<To print a test page>
1. Press the [Utility/Counter] key on the copier.
2. Touch [Controller Details].
3. Touch [Menu].
4. Select "Print Pages".
The names of the pages that can be printed are
displayed.
5. Select "Configuration".
Timing for turning on the copier with con-
nection method b from "V. Connecting the
copier and image controller to a network"
Turning on
Turn on the devices in the following order.
1. Turn on the softswitch on the image controller.
2. Check that the image controller is ready to be
used, and then turn on the copier.
If the copier is turned on too soon, a malfunction
may occur. For details, refer to the following infor-
mation.
Timing for turning on the copier
With connection b described in "V. Connecting the
copier and image controller to a network", the copier
and image controller communicate internally through
a crossover cable.
If the DHCP function is enabled on the image con-
troller, the network interface card in the copier per-
forms a DHCP request when it is turned on in order
to acquire the IP address necessary for communi-
cating with the image controller.
Since a DHCP request is performed when the copier
is turned on, the IP address cannot be acquired if
the copier is turned on before the image controller is
ready to be used, preventing communications with
the image controller.
One of the following IP addresses can be assigned
to the copier.
172.17.249.2
10.249.249.2
E-10
Advertisement
