Advertisement
10. While aligning the matchmarks on the relay cir-
cuit board and the main circuit board, connect
the connector coming from the back side of the
relay circuit board to the connector on the main
circuit board.
11. Using the two screws, secure the relay circuit
board.
Note:
Be sure to use the two screws removed in step 7.
12. Using the two supplied shoulder screws for the
relay circuit board connector, secure the connec-
tor of the relay circuit board.
13. Reinstall the internal bracket that has been
removed in step 5 (11 screws).
14. Reinstall the rear right cover that has been
removed in step 4 (four screws).
15. If the fax kit was removed in step 3, install it at
the location from where it was removed.
16. Remove the rear lower cover (six screws).
A0YEIXC041DA
17. Remove the right side rear lower cover (two
screws).
A0YEIXC017DA
18. Remove the center cover from the right side rear
lower cover removed in step 17 (two screws).
A0YEIXC018DA
E-4
A0YEIXC042DA
A0YEIXC046DA
A0YEIXC043DA
Advertisement
