4. Remove the rear right cover (four screws).
5. Remove the internal bracket (11 screws).
6. Remove the interface connector cover for the
copier (one screw).
(Do not use the removed connector cover.)
7. Remove the two screws for the main circuit
board.
Note:
The two screws removed here will be used to
install the relay circuit board.
A0YEIXC011DC
8. Attach the two supplied shoulder screws for
mounting the relay circuit board to the main cir-
cuit board.
A0YEIXC012DB
9. Mount the supplied relay circuit board as shown
in the illustration
A0YEIXC013DB
E-3
.
A0YEIXC014DA
A0YEIXC015DB
A0YEIXC016DA