Related Manuals for Giandel PM-1600KAR
Summary of Contents for Giandel PM-1600KAR
- Page 1 DC TO AC POWER INVERTER SER'S ANUAL Model: PM-1600KAR □ PM-2000KAR □ PM-2500KAR □ PM-3000KAR □ Warning: This manual contains important safety and operating instruction. Please read it carefully before use the unit. Service support: support@giandel.com.au...
-
Page 2: Specifications
Specifications： Item PM-1600KAR PM-1600KAR PM-2000KAR PM-2000KAR Item PM-2500KAR PM-2500KAR PM-3000KAR PM-3000KAR Rated input voltage 12VDC 24VDC 12VDC 24VDC Rated input voltage 12VDC 24VDC 12VDC 24VDC Continuous power 1600W 1600W 2000W 2000W Continuous power 2500W 2500W 3000W 3000W Peak power Peak power... - Page 3 1. Brief 3. PARTS LIST Our power inverter is an advanced tool of power conversion, and it can supply (1. Back panel) you with AC power converted from DC power source. Not only can be used in cars, Positive of DC vessels and camping, but also can be used in emergency the power fails.
- Page 4 3. Remote controller box 5. Using time of battery 1. Current and voltage: Normal working indicator The battery is used to supply the DC input voltage required by the product, and its rated voltage must be in line with the rated input voltage of the inverter, beyond Power switch the input voltage range of the inverter, and the cross connection will cause the (Switch)
- Page 5 The ground terminal has already connected to the ground wire of AC output Notice: receptacle through the internal connecting wire. The ground terminal must be 1.The above table is only for your reference. In practice, the thick wire can be connected to the ground wire, which will vary depending on where the power replaced by two thin parallel wires if only the total section acreage of the wire meets inverter is installed.
- Page 6 Warnings: 1) The remote is designed to be mounted on a dash or other surface where a hole 1.Make sure that the switches of the inverter and appliance power are in OFF should be cut so that it sits flush. T his is not a requirement however just a position before connection.
- Page 7 2) Connect the solar panel’s positive and negative electrode to the positive and MODIFIED negative terminal of the solar input of inverter, pay attention to the correct polarity. SINE WAVE 115V/230V A C 3) Normal charging panel quantity of electric charge indicator lights light up, the SINE WAVE user can know the size of the battery charging voltage, when the "full"...
- Page 8 2. Under voltage protection: The inverter will automatically shut down when the 14. Failure guidelines input DC voltage is lower than 9.5V(19V/38V).The buzzer will whistle continuously and the green light is off, red light is on. Please turn off the inverter and use it after 1.
Need help?
Do you have a question about the PM-1600KAR and is the answer not in the manual?
Questions and answers