System Test - Honeywell Home T2 Pro THECC11060MX Installation Instructions Manual

System test

1 Wait 5 minutes to allow thermostat to sense the
room temperature correctly (after this time a
change in the temp displayed could occur).
2 Press the Mode button until "Manual" flashes on
the left side. Press Select.
3 "Pump Only" flashes on the right side. Press Select
and verify that the water pump is working.
4 Press the Fan button to go to High Cool mode
and verify that the water pump and motor high
speed are working.
5 Press the Fan button to go to Low Cool mode and
verify that the water pump and motor low speed
are working.
6 Press the Fan button to go to High Vent mode
and verify that the motor high speed is working
and the water pump is OFF.
7 Press the Fan button to go to Low Vent mode and
verify that the motor low speed is working and
the water pump is OFF.
8 Press the Mode button 4 times until OFF is
flashing at the left side, then press Select.
9 If the unit is not working correctly, verify there
are no loose connections or wires in the wrong
terminal of the block.
Installer setup (ISU)
1 Press and hold CENTER and
approximately 3 seconds to enter advanced
menu.
2 Press Select to enter ISU.
3 Press Select to cycle through menu setup options.
4 Press or to change values or select from
available options.
5 Press Select and confirm your settings or press
Back to ignore changes and return to ISU menu
screen to continue editing another setup option.
6 To finish setup process and save your setting,
press Home and return to Home screen.
NOTE: A list of setup (ISU) parameters and options
is on the next page.
buttons for
5
AM
M on
Pre-Wet
On
Off
Mode Menu
MCR37418
AM
M on
Pre-Wet
On
Pump Only
Manual
Mode Menu Fan
MCR37434
AM
M on
Pre-Wet
Pump Only
Manual
Mode Menu Fan
MCR37436
Home Select
MCR37446
Off