Troubleshooting - Toyotomi SmartCube User Manual

Multifunctional Unit 5 in 1
5. Keep the unit in this mode for half day until the conduit is dried. Doing this helps to keep the
inside of the unit dry and prevents mold developing
6. Clean the fi lters as per fi lter cleaning procedure
7. Turn off the unit and pull out the plug.
8. Separate the air-exhausted pipe, fi shtail and exhaust mount and store them safely as you
received them.
9. Cover the unit and keep it in a dry place.
10. Take the batteries out of remote control and store, or dispose, them safely

Troubleshooting

Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate the
warranty and may cause bodily harm.
Trouble
The unit does not work
The unit does not seem to
perform.
The unit loud
Compressor does not work
Reason
No power supply
Water-full indicator (E4)
Filter change counter indica-
tor (E8)
Timer function is active
Room temperature too low
or too high
In direct sunlight
Windows or doors open.
Large amount of people or a
heat source in the room.
Filter is very dirty
Air inlet or air outlet is
blocked
Room temperature is lower
than setting temperature
The unit is not put on fl at
surface
Overheating protection is
active
33
Solution
Power-on and turn on the
unit.
Drain the internal / external
water tanks
Change fi lters and / or reset
the counter by pressing fan
speed key for 3 seconds
Cancel Timer function (press
power on)
Use only in ambient tem-
peratures between 7-35℃
Draw the curtains, also UV
affects RC
Κλείστε τις πόρτες και τα
παράθυρα
Close windows and turn on
another air conditioner
Clean or change the air fi lter
Clear out debris
Change the setting tempera-
ture
Put the unit on fl at and hard
surface
Check venting.
GB