Adjusting The Call Volume; Panic Alarm; Automatic Door Opener - urmet domus IPerCom 1160/3 User Handbook Manual

Number of presses of the button
1
2
3
4
5
After one second, the multicolour LED (6) will blink red for the number of times the button was
pressed in sign of confi rmation and then will start blinking with yellow light again.
3. press the button
selection;
4. after having made the selection, the user can:
– select a different call source for which to change the call tone, by repeating the operation from step 2,
– close programming mode by holding button
10 minutes the device exits programming state and the changed parameters are saved (two long
beeps are heard).
2.8.

ADJUSTING THE CALL VOLUME

Proceed as follows to adjust the call volume (from calling station and to fl oor):
1. enter programming mode by holding button
blink slowly to indicate that programming mode has been selected and the door phone will beep 3
times;
2. pressing the button
according to the sequence LOW, HIGH, MUTE);
3. close programming mode by holding button
minutes the device exits programming state and the changed parameters are saved (two long beeps are
heard).
2.9.

PANIC ALARM

The "Panic Alarm" signal can only be activated if a button was connected to the "PANIC" terminals.
When the button is pressed, the door phone emits the fl oor call (even if the door phone was in
mute mode).
IMPORTANT The following requirements are needed for the panic alarm function:
• the system has a switchboard
• the system was confi gured appropriately (for more information see the Ipercom handbook on the www.
urmet.com website);
• the switchboard is manned;
• the switchboard operator is instructed on what to do if a panic alarm is received.

2.10. AUTOMATIC DOOR OPENER

To activate the automatic door opener service:
1. enter programming mode by holding button
blink slowly to indicate that programming mode has been selected and the door phone will beep 3
times;
2. press the button
• if the function was active, the multicolour LED (6) blinks
• if the function was deactivated, the multicolour LED (6) is off;
3. close programming mode by holding button
minutes the device exits programming state and the changed parameters are saved (two long beeps are
heard).
Only after having exited programming mode.
(4)
10
to scroll the 5 available ring tones; the multicolour LED (6) blinks red to confi rm the
will generate a confi rmation beep at the new set call volume (the volume changes
:
Call source
From main calling station
From secondary calling station
Floor call
Intercom call
From switchboard
pressed for longer than 5 seconds; in all cases, after
pressed for longer than 5 seconds; the yellow LED will
pressed for longer than 5 seconds; in all cases, after 10
pressed for longer than 5 seconds; the yellow LED will
with green light;
(4)
pressed for longer than 5 seconds; in all cases, after 10
DS1160-008