Battery Installation For Remote Control; First Time Use; Battery Precautions; Remote Control Operation Range - Magnavox MR4207 Owner's Manual

BATTERY INSTALLATION FOR REMOTE CONTROL

FIRST TIME USE

●
Remove and discaed the insulation tab as figure on the right.
●
Replacing the button cell of the it when it was drained as follows:
1. Push and slide out the battery holder as figure 1 below.
2. Replace the button cell with a new CR2025 button cell as the polarity markings
on the rear of the Remote Control.
3. Close the battery holder.
Fig.1 Fig.2

BATTERY PRECAUTIONS

Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the battery
compartment, a reserved battery may cause damage to the device.
3. Do not mix different types of batteries together ( e.g: Alkaline and Carbon-zinc ) or old
batteries with fresh ones.
4. If the batteries in the device are consumed or the device is not to be used for a long period of time,
remove the batteries to prevent damage or injury from possible leakage.
5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture.
( Follow battery manufacturer's instructions.)
6. The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
7. Clean the battery contacts and also those of the device prior to battery installation.
The remote control supplied with a coin/button cell battery. If the coin button cell battery
8.
is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used battery away from children. If the Battery compartment does
not close securely, stop using the product and keep it away from children. If you think batteries
might have been swallowed or placed any part of the body, seek immediate medical attention.

REMOTE CONTROL OPERATION RANGE

● When there is an obstacle between the remote
and the transmitter, the unit may not operate.
● When direct sunlight, an incandescent lamp,
fluorescent lamp or any other strong light shines
on the REMOTE SENSOR of the unit, the operation
of the remote may be unstable.
Fig.3
4
Remote Sensor
Approx.16 feet
° °
30 30