Magnavox MR4207 Owner's Manual page 7

AUX IN:
To listen from an external Audio Player such as a MP3 Player, Discman ...etc.
1. Connect one end of the supplied Audio Connection Cable to the AUX Out / Line Out /
Phone Jack on the external Audio Player.
2. In power on mode, connect the other end of the cable to the AUX (in) Jack on the rear of
unit as the figure below. The unit will turn to AUX (in) mode automatically.
To AUX Out/Line Out/Phone Jack
on the external Audio Player
3. Play the music on the connected Player as usual. (Make sure the volume level of the
connected Audio Player is turned to high level.)
4. During playback:
Turn the VOLUME Knob on the unit or press the VOL (Volume) +/- Buttons on the Remote
Control to adjust volume level as desired.
Press the (Mute) Button on the Remote Control to turn off the sound; press again to turn
the sound back.
5. When finished listening,
unit or press the Button on the Remote Control to turn the unit to Standby mode.
In Standby mode:
Press the Button on the Remote Control to turn on the unit. Or,
Slide the Power ON/OFF Switch on the rear of unit to OFF position then slide to ON
position to turn on the unit.
NOT ES :
If the Audio Connection Cable was plugged into the AUX (in) Jack, the Bluetooth function
will auto cut. Unplug the Cable from the AUX (in) Jack before use Bluetooth function.
For energy saving, if unit is not to be used for an extended period of time, turn off the unit
by slide the Power ON/OFF Switch to OFF position.
slide the Power ON/OFF Switch to OFF position to power off the
7
To AUX IN Jack on
the rear of the unit