PE micro Cyclone for STMicro User Manual page 25

CYCLONE FOR STMICRO
Figure 3-19: Jumper Settings for Target Power Connection via Cyclone for
STMicro Board Power and Power Out Jack of Cyclone for STMicro
Jumpers 2 and 3 are installed. Jumpers 1, 4, and 5 are left open.
3.15.3 Using Cyclone for STMicro Board Power and Debug Connector TVCC
The target power supply is not needed. Pin 1 of the Cyclone for STMicro 4-pin
debug connector provides the appropriate voltage for corresponding STM8
targets. Pin 1 of the Cyclone for STMicro 20-pin debug connector provides the
appropriate voltage for corresponding STM32 targets. Pin 11 of the Cyclone
for STMicro 14-pin debug connector provides the appropriate voltage for
corresponding SPC56 targets. The Power Out jack of the Cyclone for
STMicro connector is not needed. Figure 3-20 shows the connections.
Figure 3-20: Via Cyclone for STMicro Board Power and Debug Connector TVCC
Jumpers 1, 2, and 3 are enabled as shown in Figure 3-20.
20 Cyclone for STMicro - User Manual