3.9
4-Pin ERNI Connector (for STM8 Targets)
The Cyclone provides an ERNI 214012 Right Angle Male Single Connector
for STM8 targets. The 4-pin connector adopts the standard pin-out as
specified by STMicro. Please note that the ERNI connector is keyed. The pin
definitions are as follows:
The physical location of the ERNI 214012 connector is displayed below:
Cyclone for STMicro - User Manual
Figure 3-7: Dual-Row Header Mechanical Drawing
PIN 1 - TVCC
PIN 2 - SWIM
PIN 3 - GND
PIN 4 - RESET
CYCLONE FOR STMICRO
11