Radio Reception; Tuning To Radio Stations; Programming Radio Stations - Philips MC-M350/25 User Manual

Radio Reception

Tuning to radio stations

1
Select TUNER source.
➜ TUNER is displayed briefly.
2
Press BAND (or DISPLAY on remote
control) once or more to select your waveband
(FM/ MW/ LW).
3
Press down TUNE
button.
➜ The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: SEARCH.
➜ If a FM station is received in stereo,
shown.
4
Repeat step 3 if necessary until you find the
desired station.
G To tune to a weak station, press TUNE
briefly and repeatedly until you have found
optimal reception.
14
or and release
is
or

Programming radio stations

You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden. The system will only program
stations which are not in the memory already.
1
Press PRESET
or
number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROG/ REV (PROGRAM on remote
control) for more than 2 seconds to activate
programming.
➜ AUTO is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by MW, LW. The last
preset automatically stored will then be played.
Manual programming
1
Tune to your desired station (see "Tuning to
radio stations").
2
Press PROG/ REV (PROGRAM on remote
control) to activate programming.
3
Press PRESET
or
from 1 to 40 to this station.
4
Press PROG/ REV (PROGRAM on remote
control) again to confirm the setting.
➜ The preset number and the frequency of the
preset station are shown.
5
Repeat the above four steps to store other
stations.
G You can override a preset station by storing
another frequency in its place.
to select the preset
to allocate a number