Installation; Mounting Method; Maintenance And Inspection - Hitachi HIDIC EH-150 Instruction Manual

9. Mounting

9.1 Installation

EH-PT4 module can be installed on both the basic base and expansion base.
(1)Precaution on installation
Upon the installation of the EH-150 series, consider the operability, maintainability and environment.
(a)For use in proper ambient temperature range
• Secure a sufficient space allowing a good ventilation.
• Do not install the module just over a device generating a great amount of heat(such as heater, transformer and
large capacity resistor).
• If the ambient temperature around the module exceeds 55 , set a fan or air conditioner to keep the
temperature below 55 .
(b) Do not install the module in panel provided with a high-voltage device.
(c) Keep more than 300 mm away from a high-voltage line and power line.
(d) Installing the basic base 1,000 mm through 1,600 mm from the floor improves the operability.
(e) Secure a clearance of more than 50 mm between the upper and lower sections of the module for ventilation
and maintenance. For the right and left directions, secure a clearance of more than 10 mm.
(f) Never pull out or inset a alive line of the module.

9.2 Mounting Method

(1)Check of the connector
Before and after the installation, check the following two points.
(a) Is there any abnormality on the connector of the basic base or extensive base?
(b)Is there any abnormality in the connector or the module side?
(2) External wiring
Before running, confirm the following items:
(a)Check whether the connection of the external wiring is right.
(b)Check whether the terminal block and the module are stabilized.

9.3 Maintenance and Inspection

Perform periodic inspection every six months according to the procedure mentioned below.
(1) Remove dust and dirt off the terminal board.
(2) Confirm that the fixing screws of the external wiring terminal board and module are tightened firmly.
9. Mounting
9-1