Network Settings Recovery - 360 Vision Predator Hybrid PREDHYB-PSU-SM Installation & Configuration Manual

Predator Hybrid Installation Manual V2.1.25
Video Plug-in
Video Plug-in - Choose video plug-in, choice of VLC, JPEG (every 5 seconds), or none.
•
Unicast Transport - Choice of UDP or TCP.
•
Network Latency - Adjust Video player latency/buffer.
•
• Download - Download video plug-in from the camera.
Desktop Application
Framework - Download framework to run desktop application.
•
Application - Download software for the standalone application.
•
Notes - Notes on how to install the desktop application.
•

12 Network Settings Recovery

When network settings are changed, the IP address, Net Mask and Gateway are validated before they are
saved. However if the settings are such that the Predator Hybrid has settings which mean that it cannot be seen
on the user's network, it may become necessary to use the 'Network Settings Recovery' feature as described
below.
The 'Network Settings Recovery' IP address may conflict with an IP address that is already defined on the
network, it may be necessary to disconnect the Predator Hybrid from the network and control it locally using a
network connection to a laptop so that the IP address can be set to a suitable setting before the Predator Hybrid
is reconnected to the main network.
Procedure for 'Network Settings Recovery'
If necessary disconnect the Predator Hybrid from the main network.
Turn power to the Predator Hybrid OFF for 3 seconds.
Turn power to the Predator Hybrid ON for 4 seconds.
Repeat the above five times.
On the final power ON, leave the power switched on for at least 5 minutes to allow the Predator Hybrid to
initialise.
(See section Locating the Predator Hybrid on your network - page 20).
OK to apply the new settings into the Predator.
Cancel to abandon the changes to the browser settings.
© 360 Vision Technology Ltd.
Page 44