Maintenance - GMC GMCSDS18 Manual

Screwdriver use
1. Fit a ¼" (6.35mm) screwdriver bit holder to SDS Plus adaptor into the Chuck (15)
2. Select gear 1 using the Gear Switch (4)
3. Rotate the Mode Selector (2) to Drill
IMPORTANT: This drill is not optimally configured for driving screws and should only be used for driving
screws partially into or out of material to speed up operation.
• Drive screws into material until the screw head is no less than 10mm above the material or the drill slows
due to resistance. Ensure the tool motor and gearing is not under excessive strain
• Remove screws by first unscrewing by hand until only light resistance to turning is felt, then fully remove
with the drill
Accessories
• A range of accessories, including additional batteries, SDS Plus drill bits and adaptors are available from
your GMC dealer. Spare parts can be purchased from your GMC dealer or online at www.toolsparesonline.
com

Maintenance

WARNING: Remove battery from the tool before cleaning and maintenance operations.
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal parts to wear quickly, and shorten
the machine's service life. Clean the body of your machine with a soft brush, or dry cloth. If available, use
clean, dry, compressed air to blow through the ventilation holes
Storage
• Store this tool and its accessories after use in its case, in a dry, secure place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional and are
not viable for repair.
• Do not dispose of power tools, batteries or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of power tools
and batteries
9
GB