IDEAL PRO Series Installation And Servicing page 4

DESIGN
DESCRIPTION
Figure 1
Ideal Pro
INDIRECT
Ideal Pro is a range of unvented hot water
storage cylinders, manufactured in the latest
high quality duplex stainless steel. They are
designed to provide mains pressure hot water
and are supplied as a package which complies
with Section G3 of the Building Regulations.
The appliance is extremely well insulated using
high density HCFC free foam insulation with an
ozone depleting potential (ODP) of zero and a
global warming potential (GWP) of 2. It is fitted
with all necessary safety devices and supplied
with all the necessary control devices to make
installation on site as easy as possible.
Ideal Pro Indirect
Ideal Pro Indirect is an unvented hot water
storage cylinder and is provided with a
high efficiency internal primary coil which is
designed for use with a gas or oil boiler and
is suitable for both open vented and sealed
pumped primary systems.
When used with a sealed heating system the
boiler must incorporate its own energy cut-out
overheat thermostat.
Ideal Pro Indirect models are listed in Table 1
on Page 6 & 7.
Note:
The cold supply elbow c/w drain tapping
must be fitted as shown in figs 1. A flexible
hose can then be connected to the drain
tapping and, providing the hose runs below
the lowest level of the cylinder, then all
the water contents can be drained out by
syphonic action. (The cold feed pipe dips
internally to the base of the cylinder.)
Page 4