Advertisement
2
3
4
SWAGED END
OVAL
WIRE
SWIFTREE SECTION ASSEMBLY
NOTICE
The Lower Ladder Section has an oval shaped wire
ring welded to the base (see figure 3). It should be
the only section with this ring. It must always be used
as the bottom / ground level ladder section.
1. Insert the swaged end of the bottom section into the open end
of one of the remaining sections as shown in figure 4.
2. Repeat Step 1 for the other ladder sections. Double check to
insure that all three stand-off brackets are facing the same direc-
tion before use. See figure 5.
WARNING
!
ALWAYS ENSURE that the U-shaped stand-off
brackets on each section are an the same side once
assembled.
ALWAYS ENSURE that the sections are fully slid
together so each end contacts the rivet stop point
before climbing.
5
STAND OFF
BRACKETS
FACING SAME
DIRECTION
PG 3
Advertisement
