Summit rsxHAWK Manual page 4

INSTALLATION (continued)
3. Connect the Talon Attachment Bracket to the tree
next. Position the bracket as shown in figure 3. The
open end of the bracket should face up (see Side
View, figure 5). Wrap the webbing strap around the
back of the tree and connect the double J-hook to
the opposite side of the bracket as shown in figure 4.
The double J-hook must be attached as shown in
figure 4 (flat side toward the tree). Repeatedly pull
the free webbing end of the strap to cinch it down to
the tree.
Please refer to figure 5 for proper strap placement on
the tree and for a buckle threading diagram.
WARNING
!
ALWAYS follow all warnings and expiration dates
listed on the Talon Attachment Bracket Strap warning
label. ALWAYS inspect the strap for wear and cuts
before each use. NEVER use a damaged strap.
5
BUCKLE
(LOOKING DOWN)
4. Haul your Raptor Series Hang-On stand up to your
current position using your pull-up rope.
5. Lift the stand up and set the cable cross bar down
into the Talon Bracket as shown in figure 6.
WARNING
!
The cable cross bar must be fully seated inside the
Talon Bracket in front of the riveted security clip as
shown in figure 7.
The bracket will rotate toward the ground as
weight is applied to it. This is normal.
Remove the green tourniquet buckle strap and fold
the platform down.
PG 4
BRACKET
TREE
SIDE VIEW
TALON
ATTACHMENT
BRACKET
(PN 85159)
4
DOUBLE J-HOOK
BRACKET
7
DOUBLE
J-HOOK
6
www.summitstands.com
3
CABLE CROSS BAR