Section 4 - Assembly - Summit 82077 Manual

4
ASSEMBLY
CAM BUCKLE ATTACHMENT
1. Position a single Buckstep section and cam buckle strap as
shown in figure 1.
2. Start with the sewn loop end that is NOT attached to the
cam buckle. Push this through the metal bracket from the
bottom up as shown in figure 2.
3. Push the sewn loop that is attached to the cam buckle and
the cam buckle through the loop as shown in figure 3.
4. Thread the entire buckle and remaining strap through the
loop as shown in figure 4.
5. Pull snug to create a cinch knot. Your completed Buckstep
should look like figure 5.
6. Repeat Steps 1 -5 for the remaining sections.
2
4
1
3
5
!
ALWAYS ENSURE that the cam buckle faces out with no
twists in the strap.
WARNING
PG 3