Assembly And Use - Summit 85241 Manual

2

ASSEMBLY AND USE

MODELS 85241, 85242, 85243, 85244
WARNING
!
NEVER DISCONNECT FROM YOUR SAFETY HARNESS
OR SAFETY LINE ONCE YOU LEAVE THE GROUND!!
1. Climb your ladder using the methods described in your written ladder instructions.
2. Using a pull-up rope, pull the blind up to your ladder platform.
3. While standing on the platform, step through the opening in the blind and pull it up around you. The velcro straps should be
at the top.
4. Align the zippered door with the ladder on the stand.
5. Slide the blind over the side rails and shooting bar.
6. Attach the Velcro straps around the rails and shooting bar to secure the top of the blind.
7. Pull the bottom of the blind out, around and under the base of the platform.
6. Unzip the door. Carefully reach down and pull the two straps at the base of the zippered door to tighten the blind around
the platform. Tie the straps off to hold the tension on the base of the blind.
MODEL 85245
WARNING
!
NEVER DISCONNECT FROM YOUR SAFETY HARNESS
OR SAFETY LINE ONCE YOU LEAVE THE GROUND!!
1. Climb your ladder using the methods described in your written ladder instructions.
2. Using a pull-up rope, pull the blind up to your ladder platform.
3. While standing on the platform, line up the zippered door with the ladder on the stand. The velcro straps should be at the
top. See figure 1.
4. Attach the first few velcro straps to the front of the ladder rail and shooting bar as shown in figure 2.
5. Carefully reach down on either side of the blind and attach the S-hook from the blind to the ladder tubing as shown in
figure 3 and figure 4. Repeat for the other side.
6. Attach the remaining velcro straps to the top frame of the ladder stand.
7. The finished blind should look like figure 5.
PG 2
www.summitstands.com