Table of Contents
Advertisement
CAT5 MULTI VGA SYSTEM
3.2.3 Skew Compensation Settings
The AC1062A-xx, AC1063A-xx, AC1064A-xx receivers are available with an optional
skew compensation module to adjust for signal timing differences due to differing pair
lengths within the CAT5 cable. Using the delay signals, skew may be compensated
from 2 to 65 nanoseconds in 2 nanosecond increments on each individual color pair.
If skew compensation is required, but the skew comp module is not installed, call for
technical assistance.
An image file is available to assist in these settings. See Figure 3-6 for an example.
1.
To adjust individual colors, press the EQ/Skew knob until the desired color LED is
on for the R/G/B LED (AC1062A-xx, AC1063A-xx) or the desired color LED is lit
(AC1064A-xx). The LED color corresponds to the color channel being adjusted.
2.
Using the image utility, turn knob to add/subtract delay timing until a single
vertically aligned line of red, green, blue is obtained.
3.
When complete press EQ/Skew knob until R/G/B LED (AC1062A-xx, AC1063A-xx)
is off or all LED's are off (AC1064A-xx).
Not all colors will have the same delay settings.
Figure 3-6: Image Adjustment Utility—Skew
12
Advertisement
Table of Contents
