Black Box ACS4001A-R2-R Quick Install Manual

1
Transmitter and Receiver Quick Install Guide
Connects to the ServSwitch DKM DVI-D
KVM Switch.
Thank you for purchasing the Black Box transmitter (ACS4001A-R2-T) or receiver (ACS4001A-R2-R) unit. This product was
designed to be used with the ServSwitch
chassis versions:
• ACX0808 (8 user X 8 computers)
• ACX0816 (8 user X 16 computers)
• ACX0832 (8 user X 32 computers)
• ACX1616 (16 user X 16 computers)
• ACX1632 (16 user X 32 computers)
Quick Setup
To connect the transmitter (ACS4001A-R2-T) or receiver (ACS4001A-R2-R) to the DKM DVI-D KVM Switch, follow these
instructions and refer to the diagram on the back of this page:
1. Install the ACS4001A-R2-T unit(s) near the computer side and the ACS4001A-R2-R unit(s) near the user side.
2. Use CATx cable to interconnect the transmitters (ACS4001A-R2-T) to the RJ-45 CPU ports and the receivers (ACS4001A-R2-R)
to the RJ-45 CON ports of the DKM switch. (If you need to extend the distance farther than 459 feet (140 meters), use the
ACX1000 CATx to CATx repeater to double your length.)
3. Power on the system and verify the LED status on the transmitters and receivers to make sure everything is connected
correctly.
Customer
Support
Information
DKM DVI-D KVM Switching System. This product is compatible with the following
™
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)
FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746
Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018
Web site: www.blackbox.com • E-mail: info@blackbox.com
BLACK BOX
February 2010 July 2010
MT1000A-85-R4
ACS4001A-R2-T
ACS4001A-R2-R
®