After Every Use; Maintenance And Storage; Motor Care; Water Cooling System - Carson Speed Shark Brushless Instruction Manual

AFTER EVERY USE

Drain the water from the hull.
Use the drain plug at the rear of the boat to do this.

MAINTENANCE AND STORAGE

Dry the inside and outside of the boat, including the water cooling
pipes and the motor casing. Remove the hatch before putting the
boat into storage.
Repair any damage that may be present before putting the boat
into storage.
Grease the drive shaft (grease not included)

MOTOR CARE

You can extend the service life of the motor by avoiding hot
situations.
You should therefore avoid:

WATER COOLING SYSTEM

This boat has a water cooling system for the motor and the drive
controller.
Important !!
If no water comes out of the water outlets when travelling
forwards, the boat must be returned to the waterside imme-
diately.
The Velcro strips in the boat retain water. To dry them, press with
a dry cloth.
The boat must not be stored in direct sunlight or an environment
that is too hot.
- Continuous stopping and starting
- Continuously driving at full speed
- Using the boat in rough conditions
Remove any blockages or obstacles and remove any kinks from the
cooling water system.
Failure to pay attention to this will lead to overheating and damage
to the electronics!
25 // GB