K9000 2.0 Inspection and Acceptance on Delivery: ............3 K9000 2.0 System Specifications ................4 Installation: ........................5 Levelling and Positioning the K9000 2.0 ..............5 Connecting the Water Supply and Waste connection to the K9000 2.0....6 2.2.1 Connecting the Water Supply ................6 2.2.2 Hot Water ......................
K9000 2.0 Inspection and Acceptance on Delivery: Inspect the K9000 2.0 on arrival and prior to unwrapping to ensure there is no travel damage. If there is any damage, please contact Tru Blu Dog Wash before accepting delivery. Caution should be taken when the K9000 2.0 has been delivered and is being unloaded. The K9000 2.0 weighs approx.
There are 4 adjustable feet and 2 mounting feet, place a level along the back of the K9000 2.0 and adjust the feet according to get the K9000 2.0 Level, place the level along the top of the cabinet running back to front to make sure it is not tilting forward or backwards.
0.5Mpa. (72 psi / 500Kpa). The picture at left shows the hot and cold-water entry points for a K9000 2.0 without an on- board hot water unit. While the picture on the right shows the water entry point for a K9000 2.0 with an on-board hot water unit.
2.2.2.1 Site Supplied Hot Water Shown below is a K9000 2.0 that was installed at a site that supplied HOT water, and as such the unit did not require to have an on-board hot water service. *Please consult with Tru Blu Dog Wash to ensure your existing hot water supply is adequate.
2.3 Connecting the Power – For Your Electrician For CE countries there will be an isolator switch supplied with the K9000 2.0, it needs to be mounted within 1.7m from the cabinet at a height between 600mm and 1900mm from the ground.
2.4 Completing the Installation Now that the K9000 2.0 has been installed you can now refit the front kicker plate removed earlier to allow the installation to proceed and peel the protective white film from the unit. You are now ready to commission the K9000 2.0.
4.2 Approved Products ® The only products that are approved for use in the Tru Blu K9000 2.0 Wash are Fido’s products produced in Australia by Mavlab Pty Ltd and those registered as a “veterinary chemical (www.mavlab.com.au) product” by the Australian Pesticides and Veterinary Medicines Authority (APVMA) for use on dogs.
8.2 Heated Dryer - Operation (Heat Settings) The K9000 2.0 dog wash comes equipped with an adjustable blower heat setting for drying dogs. This is controlled by a toggle switch. Heat Toggle Switch HEAT SWITCH This toggle switch is marked with the sticker shown on the right.
12 Operator Maintenance The K9000 2.0 can operate in temperatures from 5- 40 degrees Celsius if you experience temperatures outside of this range check with your plumber for appropriate insulation. To gain access to the cabinet, unlock the pad lock and open the door by using the handle.
Need help?
Do you have a question about the K9000 2.0 and is the answer not in the manual?
Questions and answers