Switching Off The Alarm; Station Scan; Save Station - Auriol 276111 Operation And Safety Notes

Acoustic alarm volume: A flashing VO will appear
along with a number which can be adjusted from 0 to
18. The higher the number the louder the sound.
Sunlight/Mood light mode: Used to set the colour
of the visual alarm. Select from 01 Sunlight mode and
02 Mood light mode.
Note: Please be aware that in Mood light mode you can
only choose between 5 different levels of brightness.
Visual alarm brightness: A flashing number will
appear which can be adjusted from 0–18. The higher the
number selected, the brighter the illuminated panel
will be.
Visual alarm lead time: This sets the duration of the
lead time. Choose from the following lead times: OFF
(no lead time), 5, 10, 15, 20, 25 or 30 minutes.
Note: During the visual alarm lead time a flashing
will appear in the LC-display
going off at the same time as the acoustic alarm, the
symbol will be static.

Switching off the alarm

If no button is pressed after the alarm automatically activates,
the alarm will automatically switch off after one hour and
will only reactivate the next time the alarm time occurs.
When the alarm sounds, you can switch it off with the
SNOOZE button .
15
When using the snooze function, the alarm will sound again
in 10 minutes. To completely switch off the alarm with the
snooze function activated, hold the SNOOZE button for
3 seconds or press the ALARM button
The alarm will then remain off until the next alarm time reoccurs.
Note: In clock mode, press the ALARM button
quickly switch between the "Alarm on" / "Alarm on with
snooze" / "Alarm off".
1
. With the visual alarm
3
once.
18
once to
18
Set radio

Station scan

The radio will receive FM stations at frequencies between
87.5 MHz to 108 MHz via the cable aerial
stations proceed as described below:
Press the RADIO button
in radio mode. The frequency
Hold the + button or the − button
10
The radio will start scanning for stations. The station
scan will stop on the first station found.
When pressing the + button or the − button for 3 sec-
onds again, the radio will continue scanning stations.
The VOL+ button increases the volume.
13
The VOL– button lowers the volume.
14
Aim the cable aerial
6
reception.
Press the RADIO button for the light alarm clock to
return from radio mode to clock mode.

Save station

With the light alarm clock in radio mode there are
8 memory locations for saving stations.
Hold the RADIO button
you found has been saved. The display will flash the
memory location suggested by the radio.
Press the VOL+ button
the memory location you wish to use. Press the RADIO
button to confirm your selection.
To recall a saved station repeatedly press the TEST but-
ton with the light alarm clock in radio mode until the
20
desired memory location appears in the LC-display.
When switching the radio off by pressing the RADIO
button, the radio will play the last station selected when
turned back on.
Rapid Test
Note: The light alarm clock must be in clock mode for the
rapid test.
. To scan for
6
. The light alarm clock is now
19
will be displayed.
24
for 3 seconds.
11
so the radio has optimal
for 3 seconds until a station
19
or VOL− button to select
13 14
GB/IE/NI 9