Sanyo HR-VX200 Basic Service Technical Information page 7

2-2-2. MOVEMENT CHECK LIST FOR THE MAIN PARTS OF MECHANISM
MECHANISM MODE
~
~
\_
No.
K
PRINCIPAL PARTS
T
Lu z —
1 Assy, brake t vc OFF OFF
2 Assy, brakes vc OFF OFF
3 Assy, brake soft t vc OFF OFF
I
4
I
Slide softs vc ION ION
I 5 I Assv, lever, bt
I OFF I OFF
I
6 I Spring, bt I OFF I OFF
7 Assy, lever, pinch vc UP UP
8
Gear, clutch vc
PLAY PLAY
9 Assy, lever load vc UNLO UNLO
10 Assy, brake capstan OFF OFF
'c
11 Assy, mounting incl s/t vc
12 Assy, mounting cleaner I OFF I OFF
2-2-3. CHECKING THE MECHANISM MODE
POSITIONS
Check the mark for "slide, crescent VC" from the top and
bottom sides of the mechanism to determine the
appropriate mechanism mode position.
L
Models with display tubes which come with a service
mode setting function will indicate HEX DATA on the
display tube. Refer to "3-l-l. SHIFTING TO THE SERVICE
MODE" for more details.
1.
CHECKING FROM THE TOP SIDE OF THE
MECHANISM
As shown in Fig. 2-2-2 and Fig. 2-2-3, the "slide, crescent
VC" has marking lines and symbols to indicate the
mechanism modes with the edge of the mechanism
L
chassis as a reference.
The mechanism mode can be determined from the
marking line for the "slide, crescent VC" which matches
the reference line of the mechanism chassis. The HEX
DATA can also be checked from the mechanism chassis
hole.
Note:
No
HEX DATA is indicated for the EJECT mode,
Instead, the hole will be empty.
No HEX DATA is indicated for the IN REW mode
because it is near the INITIAL mode and so cannot
be indicated. For the same reason, there is also no
marking line for the INITIAL mode.
(S): Strength (W): Weakness
OFF I OFF I OFF I OFF I OFF I OFF I OFF I ON ~N/OFI
OFF I OFF I OFF I ON I ON I OFF I OFF I OFF I OFF
ON ION ION IOFFIOFFIOFF IOFF IOFF IOFF
OFF IOFFIOFF ION ION ION ION ION IOFF
OFF I OFF I OFF 1ON(W)ION(W) 10N(S) 10N(S) ] ON(S) ION(W)
UP IUPDOWNIDOWNIUPI ON I OFF I ON I ON ] OFF I OFF
'LAY IPLAY IPLAY IPLAY IPLAY I PLAY I PLAY
I
PLAY I FF
I I I 1 I I 1 I
JNLOILO ILOILOILOILO ILO lLO ILO
OFF \ OFF I OFF I OFF \ ON I ON I OFF I OFF I OFF
ILOIUNLOI I I I I I
OFF I (ON) I (ON) I OFF I OFF I OFF ] OFF I OFF I OFF
Take this edge as the reference-line,
Indicates
HEX DATA.
Fig. 2-2-2
L.
L
-7-
Fig. 2-2-3