Warranty; Routine Maintenance - Promatic Hunter Wobble Set Up And Operating Instructions Manual

Promatic, Inc.
TO CHANGE THE BATTERIES
Remove antenna from top of transmitter
•
Remove back screws
•
Locate and replace 2 CR2016 coin cell batteries
•
Replace back and antenna
•
The Hunter Wobble is covered by a 3 year warranty to the original
purchaser of the machine.

ROUTINE MAINTENANCE

ALWAYS DISARM MACHINES AND DISCONNECT BATTERY
BEFORE MAKING ADJUSTMENTS.
Position your body and all body parts behind the unit. Never ap-
proach from the front, st and in front or to the sides of the unit.
Proper care and maintenance will greatly extend the life of your ma-
chine. We recommend the following:
Daily
Dirt, dust and target debris should be cleaned off the machine.
•
Accumulations of debris will result in broken clays, more wear on
bushing and bearings, less than optimum performance and
erodes the protective coating on the machine causing rust to
form. A shop vacuum or blower works well for this task.
Check that the batteries are fully charged. A dead or low battery
•
will result in premature motor and electrical components failure.
We recommend using a digital battery tester.
Two to Four Times a Year
The following maintenance should be performed two to four times a
year, depending on target volume:
Inspect the battery cables for loose or corroded connections.
•
888.767.2529

WARRANTY

Page 8