Promatic Hunter Wobble Set Up And Operating Instructions Manual page 2

This is an automatic machine. Targets may be released at any time.
Failure to read and understand these instructions before using this ma-
chine can result in death, bodily injury or property damage.
Read these instructions completely to insure the traps are DISARMED
properly before loading targets or performing maintenance. If you have
any questions after reading this manu al, call Promatic for assist ance.
Traps should be DISARMED when the unit is not in u se.
Position your body and all body p arts behind the unit (tongue end of
the trailer). Never stand in front of or to the sides of the unit.
SEE PAGE 3 FOR INSTRUCTIONS TO DISARM THE TRAPS
ALWAYS USE TRAVEL BO LT WHEN MO VING TRAILER
When moving the trailer, re-insert the travel bolt into the back trap.
The bolt secures the trap for travel and is required to
Always remove the travel bolt be fore ope ration. Failure to do so will
result in damage to the unit.
Breaker Box - Side View Breaker Box - Front View
Controls power to the Arms and disarms the
trap and wobble motor. trap and controls vertical
The trap will not fire and horizontal trap move-
when it has been dis- ment.
armed and the switches
on this box are in the
"off" position (the red on
the switch is visible).
Page 2 To Order Call: 1.888.767.2529
CAUTION
prevent damage to the unit.
Mounted Receiver
Receives signals from the
wireless transmitter to
control the trap and flush
sequences.
Wireless Transmitter
Controls firing of the trap
and starts and stops the
flush sequence.
Uses (2) CR2016 coin cell
batteries.