Programming Frequencies - SubSurface Instruments PL-TT Series User Manual

C p
hanging
Note: This setup procedure is not required unless the user desires to change factory settings.
The PL-TT operating programs and frequency sets are user programmable and can be changed at anytime through a quick
selection process.
r
eCeiver
To select the programming options for the
• Press and hold depressed the Power On Button.
• Pressing the FREQUENCY Button will toggle through available frequencies. Passive 512Hz, 8kHz, 33kHz, 82kHz.
• To select a frequency, press the MODE Button toggle. At the top of the LCD the count of frequencies selected will tally
up one each time a frequency is selected.
• Pressing the GAIN UP Button will change the depth reading from inches/feet to centimeter.
• A long press of the Mode Button will toggle on and off the optional ferrous locating feature (Fe).
• Releasing the Power On Butt on will exit the setup menu and save the selected frequencies for availability during normal
operation.
t
ransmitter
To select the desired frequency set for
Press and hold depressed the P
•
• Pressing the f
the Frequency Indicator section of the LCD.
• Release the P
Press the f
•
requency
To select and store the desired frequency press and hold the f
•
selected frequency will be displayed on the LCD.
• Continue to toggle through and select the desired frequencies,
Press the P
•
ower
operation.
06
SERIES
f , m
reset unCtions
r
software versIons
o
ower
B will toggle through available configurations. Repeat pressing until 'U5' is displayed in
requency utton
o Button. 'PRO' will be displayed on the LCD.
ower n
B
to toggle through the available frequencies.
utton
o
Button to shut the unit off. This will save the selected frequencies for availability during normal
n
& f
odes reQuenCies
:
eceIver
3.43
and Greater
Button.
n
:
B
for 2 seconds. The count of the
requency utton
www.ssilocators.com