Nice HySecurity Hy5B Installation Instructions

Parts in Box
• Hy5B
• 3 plastic standoffs (use 2, 1 extra)
• Installation Instructions
Hy5B Installation
To install an Hy5B vehicle detector, you will need to take the following steps:
• Test the vehicle loop.
• To use all the features of Hy5B, update the software version on the gate operator
to the latest version using S.T.A.R.T. and a PC laptop. Access free software
updates from the HySecurity website:
• Install the Hy5B vehicle detector.
• Fully cycle the gate at least 2 times to allow the detector to adjust to the effects
of the gate during travel. Drive a test vehicle over the loops.
NOTE: For in depth aspects on all features of the Hy5B, see
Guide found in the Tech Support section of our website.
Test the Vehicle Loop
Run diagnostic tests on the vehicle loops before installing Hy5B vehicle
detectors to ensure the loops are in good working condition. The following
tests cannot guarantee a functioning loop, but failure of either test means that
the loop may be damaged or need to be replaced.
1. Test – Measure the resistance of the loop and lead-in wire. It should not
exceed 4.0 ohms.
2. Test – Measure the resistance to earth ground with a Megohmeter
(Megger). It should be 100 Megohms or more. Below 50 mega-ohms, install
a new loop.
NOTE: Loops may function at 100 Megohms or less, but will not be reliable (for example, when
the ground is wet from rainfall). A low megohm reading on the resistance to earth ground usually
occurs due to broken or moisture saturated insulation. Be sure to use wire with a direct burial
jacket such as XLPE or XHHW wire. Do NOT use THHN wire.
Check the Version of Software
1. In the field, open the gate operator's Control Box.
2. To view the software version, press the RESET key. To use Hy5B features, the
software version must be h4.55 or h5.56 (or higher). Otherwise, the Hy5B
reverts to Hy5A emulation mode.
Tools Needed
• Wire cutters
• Wire stripper
• Megohmeter (test the loops)
www.hysecurity.com
Hy5B User & Reference
www.SecureOpeners.com | (800) 878-7829 | Sales@SecureOpeners.com
Installation Instructions
Hy5B Vehicle Detector: MX4125
Table 1: LED Display Status
LED Activity Indicates
OFF Hy5A mode
GREEN PULSING Heart beat
RED ON Call Mode
View display for
more information:
Initializing
RED FLASHING
or
Faulty loop
Push terminals for loop wire.
Accepts 20 - 14 AWG
Strip length: 10mm (½ to ⅜ inch)
Terminal Ground: Lightning protection
Optional connection:
Use where lightning strikes occur.
Underground
Loop
Diagram 1.
Hy5B Vehicle Detector and Loop
Condition & Resolution
Emulation mode. Some Hy5B features are unavailable.
Normal operation.
Status indicates loop activation in process.
If initializing, wait until initialization is complete.
If flashing during loop operation, take following steps:
1. Check loop wiring.
See Test the Vehicle Loop on page 2.
2. Replace loop.
3. If loop is not at issue, swap out Hy5B vehicle detector
with a known operational Hy5B.
4. If necessary, replace Hy5B.
LED
Vehicle loop features and
functions explained on
the front label.
Metal pins fit into a
socket on the controller
board.
Conduit to gate operator
Houses lead in wire
Loop wire