Advertisement
FEATURES
• 10" All-Weather Amplified Subwoofer Enclosure
• Integrated 250-Watt RMS / 500-Watt Peak Power Amplifier
• Integrated Power and Ground Connections
• Low Level Input with External Gain Control
• Dash Mount Bass Control Knob (Included)
• Mounts Into Center Console - Direct Fit, No Drilling Required
SPECIFICATIONS
• RMS Power Handling: 250-Watts
• Peak Power Handling: 500-Watts
• Frequency Response: 34Hz - 120Hz
INSTALLATION
Step 1 - Remove passenger seat from vehicle.
Step 2 - Align the enclosure with the hole in the center console with the wires facing the front of the
vehicle.
Step 3 - Slide the subwoofer into the hole until it is flush with the center console on the passenger
side.
Step 4 - Take mounting plate on driver's side and align bent tabs with center console and position
enclosure inside bent tabs.
Step 5 - Squeezing the plate against the center console, take included pan-head machine screws and
thread through mounting plate into enclosure using pre-threaded inserts. Tighten screws until plate
and enclosure are secured tightly against center console.
Step 6 - Now that the enclosure is securely tightened in place, the power and signal wires need to be
connected to the battery and signal source.
• The Red wire should be connected directly to the battery's positive terminal and fused with a 30A
fuse.
• The Black wire should be directly connected to the battery's negative terminal.
• If your vehicle is equipped with the Polaris® buss bar kit, the Red and Black wires can be
connected to the buss bar under the hood on the firewall. The Red wire will still need to be fused.
• The Blue wire can be connected to the ACC / Key Turn On located on the buss bar of any vehicle.
Step 7 - Connect the RCA inputs to the signal source of your choice
Step 8 - Turn the unit on and check to make sure everything works. Set the gain using the gain pot
that is attached to the orange / grey wires. Set the gain to the bass level desired.
Step 9 - The included EBC can be connected and mounted to a desired location to allow easy trim
adjustment of the bass level after the gain has been set.
Step10 - Replace all the parts and screws that have been removed to return the GENERAL back to its
completely assembled state.
3
M T X . C O M
Advertisement
