Nice Era Fit E S Instructions And Warnings For Installation And Use page 9

5.9.2 - Memorising a second transmitter in "Mode II"
Warning! – This procedure memorises the new transmitter in "Mode II", regardless of the Mode in which the old to transmitter was memorised.
Before starting the procedure, bring the awning (or shutter) to the midpoint of its stroke.
01. (on the new transmitter) Hold the key to be memorised down for 8 seconds (for example: the n key), then release it (in this case the motor does not perform any
movement).
02. (on the old transmitter) Keep the n key pressed and wait for the motor to perform 4 movements. Upon completion, release the key.
03. (on the old transmitter) Briefly press the n key a certain number of times depending on the and you want to memorise:
1 pulse = (step-by-step commands) Open > Stop > Close > Stop > ...
2 pulses = (step-by-step commands) Open > Stop > Open > Stop > ...
3 pulses = (step-by-step commands) Close > Stop > Close > Stop > ...
4 pulses = Stop command
After about 10 seconds, the motor performs a number of movements equal to the number impulses given with the transmitter.
04. (on the new transmitter) Press the same key as you pressed in point 01 and hold it down while the motor performs 3 movements. Upon completion, release the
key. Warning! If the motor performs 6 movements, it means that its memory is full.
01
example
New
03
Old
04
same
01
New
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds.
5.10 - Memorisation of a climate sensor connected via radio
To perform the procedure you must have a transmitter ("old") already memorised in "Mode I".
Before starting the procedure, bring the awning (or shutter) to the midpoint of its stroke.
01. (on the climate sensor) Keep the yellow key pressed for 10 seconds and then release it (in this case the motor does not perform any movement).
02. (on the old transmitter) Give for 3 pulse to the n key, provided it has already been memorized.
03. (on the climate sensor) Keep the yellow key pressed for 2 seconds: the motor performs 3 movements to confirm the memorisation. Warning! If the motor per-
forms 6 movements, it means that its memory is full.
01
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds.
02
8
sec.
Old
x 1 = Open > Stop > Close > Stop > ...
x 2 = Open > Stop > ...
x 3 = Close > Stop > ...
0,5
sec.
x 4 = Stop
3
5
sec.
02
"P1" "P1"
1 0
sec.
Old
4
5
sec.
10
sec.
03
X 3
0,5
sec.
1 /
2 /
?
3 /
4 /
"P1"
3
2
sec.
English – 8