Further Functions - Kärcher SensoTimer ST6 Duo eco!ogic Original Instructions Manual

Preparation / teaching sensor 2*
* depending on model
 Figure 11
The setting process of sensor 2 starts
automatically after the watering setting
of water outlet 1. If the water outlet 1 re-
mains inactive, teaching of the water
outlet 2 must be enabled by pressing
the OK button. The seconds countdown
starts for water outlet 2. Teaching of
sensor 2 is equivalent to sensor 1.
Note: In order to change the operating
mode of an outlet or to add a sensor, the
teaching process must be restarted.
 Remove the batteries from both sen-
sors and the control unit.
 Reinsert the battery in the control unit.
As soon as the symbols appear on the
display, press the OK button until the
time on the display is flashing.
 Reset the time and start the teaching
process of sensor 1, then of sensor 2.
Irrigation settings of water outlet 2
 Identical with "irrigation settings of wa-
ter outlet 1".

Further functions

Changing the settings of the water
outlets
 The menu button activates the settings
mode.
 Arrow keys select the water outlet to be
set, OK button starts the adjustment
cycle.
 The settings remain saved even without
battery supply.
Manual irrigation of the water
Valves can be opened manually:
 The menu button activates the settings
mode.
 Use the arrow keys to select the tap and
confirm your selection with the OK but-
ton.
 The valves are opened/closed by re-
peatedly pressing the arrow keys.
 The esc button terminates the manual
irrigation and switches back into the au-
tomatic mode.
Quick access manual watering
 Can be activated in every mode (auto-
matic watering and 24h-function).
 Hold the left arrow key down for at least
3 seconds in order to open the left valve
manually.
Depending on the scope of delivery, the
same procedure with the right arrow
key applies to open the right valve.
 The valve is open.
 Press the left/right arrow key briefly in
order to close the opened valve or to
open it again.
If both valves are closed, the device au-
tomatically returns to the previous
mode after 30 seconds.
 Terminate the manual watering by
means of the OK button or esc/menu
button. The valve is closed and switch-
es back into the automatic mode.
Failure safety function
 If the valve unit loses contact to a sen-
sor (no signal as, for example, the sen-
sor battery is empty), the watering is
time-controlled.
Note
ECO delay days are considered.
Advantage: Guarantee of continuous
watering, plants do not dry out.
– 5
EN
outlets
15