Table of Contents
Advertisement
Available languages
Available languages
SHELVING ASSEMBLY
Interior of the cabinet must be assembled before mounting the
cabinet to a wall.
A er you have reviewed and selected a shelving con guration (see Cabinet
Con gurations) you are ready to assemble the center partition and shelves in
the cabinet. For ease of assembly, do not tighten the nuts and bolts until all the
parts have been assembled.
Shelves on left
1. Center Partition Assembly
Lay the cabinet on its back on a protective surface.
Position the center partition carefully to align the holes on the bo om.
center partition has two possible positions. You should face the front ange
towards the side you want to mount the shelves as shown.
sets of mounting holes. Use the le holes when the shelves are on the right.
Use the right holes when the shelves are on the le .
partition is in the exact center of the cabinet, and that there is proper spacing
for the shelf installation.
Install and tighten the 2 nuts and bolts as shown.
Shelves on right
e
ere are also two
is will ensure that the
2. Top Shelf Assembly
e top shelf has 2 sets of holes for a aching the center partition. Use the set
of holes that will allow the partition to be centered between the 2 holes.
will ensure that there is proper spacing for the shelf installation on both sides.
Position the shelf so the front and side anges point down. Assemble the top
shelf to the center partition and the sides of the cabinet using 6 nuts and bolts.
3. Shelf Assembly
You have the choice of 3 locations for mounting the 2 shelves. You also have
the choice of having the front ange of the shelf to point up or down. Select a
location and assemble each shelf to the center panel and cabinet side using 4
nuts and bolts.
Now tighten all remaining nuts and bolts.
is
2
18
40298-1202
- Quick Links:
- Cabinet Installation
- Key Request
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Buck Commander and is the answer not in the manual?
Questions and answers
My safe combo is not working. It is a digital key pad. How do I go about getting it open without calling a locksmith and drilling?
If the digital keypad on your Stack-On Buck Commander safe is malfunctioning, you can try the following steps to open it without calling a locksmith or drilling:
1. Use the Backup Key: The safe comes with a backup key. Locate the keyhole, which is usually hidden behind the keypad or a removable cover, and use the key to open the safe.
2. Check the Batteries: If the keypad is unresponsive, the batteries may be dead. Replace them with new ones and try entering your code again.
3. Reset the Keypad: Some safes have a reset procedure that can be done by removing and reinserting the batteries or pressing a reset button inside the battery compartment.
4. Verify Code Entry: Ensure you are entering the correct code and that the keypad is functioning properly by pressing each button firmly.
If none of these steps work and you cannot access the backup key, you may need to contact Stack-On customer service for further assistance.
This answer is automatically generated
Do you know if I am able to order a replacement key if the safe serial number is know? I’m locked out and the keypad several numbers in the keypad no longer work.