Stack-On PC-1702-RFID Instruction Manual

PC-1702-RFID
Serial #:
Your Electronic Combination:
Battery Disposal
Please dispose of the used batteries per municipal or provincial law.
IMPORTANT
• Record your combination number.
• Record the serial number from the tag
on the back of the case.
• Keep keys and your combination in a
secure place away from children.
• DO NOT STORE KEYS, RFID DEVICES
OR YOUR COMBINATION IN THE CASE.
FCC COMPLIANCE
NOTE: This equipment has been tested and found to comply with the limits for the Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provent reasonable protection against harmful itererence in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occor in a particular installation. If this equipment does cause harmful interference
to radio or television reception, whitch can be determined by turning the equipment off and on, that user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Caution: Modifications not authorized by the manufacturer may void users authority to operate this device.
CAN ICES-3 (B)/NMB-3(B).
®
Instructions
CONTROL FEATURES
1.
Key lock
2.
Combination buttons
3.
Reset button (inside case)
4.
Battery Compartment (inside case)
5.
RFID Sensor
5
Hardware Included:
(2) M6 x 20 mm
(3/4" long) Screws
(2) Washers
(2) Plastic anchors
Tools Required:
Drill
Flat Head Screwdriver
10 mm Wrench
3/16" (5 mm) drill bit for drilling
into wood
40720-1702
1
16