Pro-face GP2000H Series Installation Manual page 6

*2 Pins #10 and #11 are reserved. Be sure to not connect anything to these pins.
*3 The DOUT Ground is used in common with External Buzzer Output (BUZZ OUT), DOUT 0
(Zero) Output (DOUT0.C), and DOUT 1 (One) Output (DOUT1.C).
*4 Disabled when "GP-H70 compatible mode" (set via GP2000H) is used.
Connector Type : Dsub 37-pin plug XM2A-3701 <made by OMRON Corp.>
Cover Type
• Pin #6 DC+5V Output is not protected. To prevent damage or
unit malfunction, use only the designated level of current.
Also, when this pin is not used, be sure that it does not contact
any other wires or metal. If touched, a short could occur that
could cause the GP2000H to break down or malfunction.
• Be sure to connect Pin #25 (SG) to the SG terminal of your
Host (External Device/PLC). If this is not done, the GP2000H
circuit may be damaged.
• The GP2000H series RS-422 conversion adapter (GP2000H-AP422) can be
connected to this cable.
Note
Please be aware that Digital Electronics Corporation shall not be held liable
by the user for any damages, losses, or third party claims arising from the
uses of this product.
Digital Electronics Corporation
8-2-52 Nanko Higashi, Suminoe-ku, Osaka 559-0031, Japan
URL: http://www.pro-face.com/
©Copyright 2002 Digital Electronics Corporation. All rights reserved.
GP2000H-D422-MT01-CP 2002.7 B
: Dsub 37-pin cover XM2S-3711 <made by OMRON Corp.>
- 6 -