Pro-face GP2000H Series Installation Manual page 3

<Wiring the RS-422 Dsub Cable>
Be sure to confirm the power supply is OFF prior to attaching this cable.
1) Unscrew the GP2000H unit's seven (7)
rear face attachment screws and re-
move the Cable Cover.
2) Connect this cable's three (3) connec-
tors to the corresponding GP2000H I/F
connectors.
3) Attach the GP2000H unit's Installation
Gasket, as shown below.
GP2000H unit's Gasket
4) Bend the cable to fit the GP2000H unit's cable channel, and adjust the cord guard so
that it fits securely into the GP2000H plastic case's notch. (see above)
5) Replace the Cable Cover and secure all seven (7) attachment screws in place.
Recommended screw torque is 0.5 to 0.6N•m.
Be sure the Installation Gasket is fitted securely around the cable, as shown below.
Be sure the Installation Gasket and the Cable Cover are both se-
curely attached. If they are not, the unit's specified protection
level cannot be guaranteed.
GP2000H unit's
Gasket
Cable
Cable
Cable Cover's Gasket
Cable
GP2000H unit's Gasket
- 3 -
<GP2000H unit's Rear Face>
GP2000H unit's
Gasket
I/F Connector
Cord Guard
Cable
Cable Cover
<Enlarged View>