Table of Contents
Advertisement
MAINTENANCE CHART
FREQUENCY
Daily or before each
use
After first 5 hours of
use
After 25 hours
Before storage of 30
days or more
GENERAL RECOMMENDATIONS
1. The owner's responsibility is to maintain this product. This will
extend the life of the product and is also necessary to maintain
warranty coverage.
2. Check the spark plug, drive brake, lubricate the unit and clean
the air filter once a year.
3.
Check the fasteners. Make sure all fasteners are tight.
4.
Follow the Maintenance section to keep the unit in good
operating condition.
WARNING: Before you make an inspection,
adjustment or repair to the unit, disconnect the wire
to the spark plug. Remove the wire from the spark
plug to prevent the engine from starting by accident.
MAINTENANCE
MAINTENANCE REQUIRED
Maintenance the engine.
Examine blade(s).
Remove debris from unit and mowing area
Examine all rotating and sliding parts.
Check tire inflation.
Verify that the mower housing is level.
Examine V-belts.
Check brake operation.
Change oil.
Maintenance engine.
Remove, examine, sharpen, and balance
blade(s).
Check adjustments:
a. Blade Rotation Control
b. Brake
c. Clutch
d. Steering
Lubricate chassis and mower housing.
Check the muffler:
a. Torque
b. For wear or burn out
c. Condition of spark arrestor (if applicable).
Prepare the engine for storage.
Drain fuel system.
Add fuel stabilizer.
Prepare battery for storage:
a. Remove from unit.
b. Fully charge.
c. Move to a cool dry place.
COMMENTS
Refer to the Engine Owner's Manual.
Check for cracks, wear, and damage.
.
Refer to the Maintenance section.
Refer to the Maintenance section.
Check for cracks, wear, and damage.
Refer to the Operation and Maintenance
sections.
Refer to the Engine Owner's Manual.
Refer to the Engine Owner's Manual.
Refer to Maintenance section.
Refer to Maintenance section.
Refer to Where to Lubricate instructions.
Refer to Maintenance section.
Refer to the Engine Owner's Manual.
Refer to the warnings in the Owner's Manual.
Refer to the Engine Owner's Manual.
NOTE: Torque is measured in foot pounds (metric Nm). This
measurement describes how tight a nut or bolt must be. The
torque is measured with a torque wrench.
HOW TO CHECK THE MUFFLER
Check the muffler every 50 hours. Make sure the muffler is correctly
mounted and is not loose. If the muffler is worn or burnt, replace with
a new muffler. A worn muffler is a fire hazard and can also damage
the engine.
If you mount a spark arrester to the muffler, also check the spark
arrester when you check the muffler. If the spark arrester is worn or
damaged, replace it with a new spark arrester. See your nearest
authorised service centre for a spark arrester.
23
Hide quick links:
Advertisement
Table of Contents
