Festool T 18+3 Li Original Operating Manual page 14

T 18+3 Li
8 Tool holder, attachments
WARNING
Risk of injury
XAlways disconnect the battery pack before
performing any type of work on the machine.
CAUTION
Hot and sharp tool
Risk of injury
XDo not use insert tools that are blunt or
defective!
XWear protective gloves.
8.1 CENTROTEC tool chuck [3]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks!
8.2 Chuck BF-FX [4]
For clamping drill bits and bits with max. shaft
diameter of 13 mm.
Clamp tool centrally in the chuck.
8.3 Angle attachment DD-AS [5]
Drilling and screwing at right angle to machine
(partly as an accessory).
8.4 Eccentric attachment DD-ES [6]
Screwdriving near edges with bits according to
ISO 1173 (partly as an accessory).
8.5 Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon
socket holder of the drill spindle.
9 Working with the power tool
WARNING
Risk of injury
XAlways secure the workpiece in such a manner
that it cannot move while being machined.
9.1 ON/OFF switch [1-3]
Press = ON, release = OFF
The speed of the machine depends on how
far the ON/OFF switch is pressed in.
The LED bulb [1-5] lights up when the ON/OFF
switch is pressed [1-3].
14
9.2 Bit store [1-2]
Magnetic, for storing bits and bit holders.
9.3 Acoustic warning signals
Acoustic warning signal sounds and the machine
switches off to indicate the following operating
states:
Battery low or machine over-
loaded.
– Change the battery.
– Reduce machine workload.
Machine is overheating.
– You must allow the machine
to cool down before further
usage.
Battery pack faulty or over-
heated.
– Once the battery pack has
cooled down, perform a func-
tion check using the charger.
10 Service and maintenance
WARNING
Risk of injury, electric shock
XAlways disconnect the battery pack from the
machine before any cleaning or maintenance!
XAll maintenance and repair work which re-
quires the motor housing to be opened, must
only be carried out by an authorised service
workshop.
Customer service and repair. Only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/Service
Use only original Festool spare parts!
EKAT
4
Order No. at:
www.festool.com/Service
5
3
2
1
Note the following information:
– Keep the ventilation slits on the machine free
and clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
For service, maintenance, disposal and
transport of the battery pack, note en-
closed instructions of the battery pack!