Festool T 18+3 Li Original Operating Manual page 13

4 Technical data
Cordless drills
Motor voltage
Idle engine speed *
Max. torque
soft material (wood) /
hard material (metal)
Adjustable torque **
Chuck clamping range
Drill diameter max.
wood / metal
Tool holder in drill
spindle
Weight without
battery pack with
CENTROTEC
* Speed specifications with fully charged battery
pack.
** The maximum speed is reduced in the lower
torque stages (values in counterclockwise rota-
tion).
5 Machine features
[1-1] Buttons for releasing the battery pack
[1-2] Bit store
[1-3] ON/OFF switch
[1-4] Right/left switch
[1-5] LED lamp
[1-6] Gear switch
[1-7] Drilling symbol
[1-8] Screwdriving symbol
[1-9] Drilling/fastening selector switch
[1-10] Capacity display
[1-11] Belt clip
[1-12] Torque thumbweel
[1-13] Insulated gripping surfaces (grey shaded
area)
Accessories shown or described are sometimes
not included in the scope of delivery.
The specified illustrations appear at the beginning
of the Operating Instructions.
T 18+3 Li
18 V
1st gear: 0 – 450 rpm
2nd gear: 0 – 1500 rpm
35 / 50 Nm
1st gear: 0.8 – 8 Nm
2nd gear: 0.5 – 6 Nm
1.5 – 13 mm
45 / 13 mm
1/4 "
1.1 kg
6 Commissioning
6.1 Belt clip
The belt clip allows a shot-term securing of the
device in the work clothes. Insert the belt clip on
the designated side, right or left, and fix it with
the screw [1a].
6.2 Changing the battery pack [2]
The capacity display [1-10] automatically displays
the charge state of the battery pack [1-3] when
the ON/OFF switch is actuated:
100%
0%
Recommendation: Charge battery pack before
further use.
7 Settings
CAUTION
Risk of injury
XAlways switch off the power tool before
adjusting settings!
7.1 Changing direction of rotation [1-4]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation
7.2 Changing gear [1-6]
• Gear switch forwards (digit 1 visible) = 1st gear
• Gear switch to rear (digit 2 visible) = 2nd gear
7.3 Fastening
Adjust the switch so that its marking [1-9] faces
the screw symbol [1-8].
Adjust the torque accordingly at the torque wheel
[1-12].
Position 1 = low torque
Position 25 = high torque
An acoustic signal sounds when the preset torque
is reached and the machine then switches off. You
must release and press the ON/OFF switch [1-3]
again to start the machine.
7.4 Drilling
Adjust the switch so that its marking [1-9] faces
the drilling symbol [1-7] = maximum torque.
T 18+3 Li
70 - 100%
40 - 70%
15 - 40%
< 15%
13