Rj-45/Db-15 I/O Module; Specifications - Cisco VCO/4K Mechanical Assemblies

Hide thumbs Also See for VCO/4K:

Table of Contents

RJ-45/DB-15 I/O Module

5.0 RJ-45/DB-15 I/O Module

A single RJ-45/DB-15 I/O module is tied to a Single Span T1 card, a PRI/N card, or a 120 ohm

ISDN/NET5 E1-PRI card. The module is picked up and transitioned to RJ-45 and DB-15

connectors. Each span uses one pair of connectors; i.e., one RJ45 and one DB15. Cards utilize

one or the other connector, but not both, at any one time. For example, 120 ohm E1 interfaces

typically utilize the RJ-45 connector.

The specifications for the RJ-45/DB-15 I/O module follow.

Standard Compliance:

Cisco Systems Part

Number:

Application:

Mechanical

Arrangements:

MDF Circuits:

Physical

Dimensions:

1-16

Cisco VCO/4K Mechanical Assemblies

ISO 4903, DA-15S

Single span — Contact your Cisco Systems sales representative

Four span — Contact your Cisco Systems sales representative

Connection of a T1 span or 120 ohm E1-PRI span to a VCO/4K system

Single Span T1 or 120 ohm E1-PRI — One DIN connector to one D-Sub

connector and one Accunet 8-pin modular jack (RJ-45)

Four Span T1 or 120 ohm Four Span E1 — One DIN connector to four D-Sub

connectors and four Accunet 8-pin modular jacks

Single Span T1 or 120 ohm E1-PRI — 24-VF Channel, DS-1 rate digital lines

interfacing a paralleled set of 8-pin modular and 15-pin D-sub connectors

Four span T1 or 120 ohm Four Span E1 — Four 4-wire T1 spans interfacing four

paralleled sets of 8-pin modular and 15-pin D-sub connectors

15.73 inch (400 mm) high, .77 inch (19.6 mm) wide, 5.65 inch (143.5 mm) deep

Table of Contents