Troubleshooting - Life Fitness Discover SE3HD Owner's Manual

Troubleshooting

Malfunction
No Power.
Treadmill striding belt
slips off-center.
Maximum treadmill
speed is reduced.
Rubbing sound comes
from underneath
treadmill.
Display does not
illuminate when
machine is powered on.
Probable Cause
ON / OFF switch is not in proper position.
Power source is insufficient.
Line cord is damaged.
Line cord is improperly seated in socket.
NOTE: International Platinum Club Series
Treadmills (PCST) only: You may be in "Energy
Saving Mode".
NOTE: International Platinum Club Series Units
only (PCSC, PCSR, PCSX): You may be in "Energy
Saving Mode".
Floor surface is uneven.
User is pushing striding belt. This occurs when the
runner is running faster than the striding belt will
travel, with the result of the striding belt being
pushed with the runner's feet.
User is stalling striding belt. This will occur with
heavier users at lower striding belt speeds. The
striding belt will "stall" if the user is traveling slower
than the striding belt speed.
Striding belt/deck malfunctions. The deck laminate
is worn through or the underside of striding belt is
glazed over (hard, glossy).
Power source is insufficient.
Foreign objects may be stuck underneath the
machine.
Loose connection at display console or motor
control board.
Corrective Action
Turn the switch to the ON position.
Plug treadmill into a dedicated 20 amp circuit.
Using a voltmeter, verify power at outlet. If no
power exists, reset circuit breaker at panel.
Replace line cord. Contact Life Fitness Customer
Support Services.
Inspect power connection at wall outlet and at
machine for proper contact.
Treadmill will go into Energy Saving Mode after 5
minutes of inactivity. To wake up the console, step
on the treadmill belt. The treadmill will
automatically wake up and the console will light
up. Waking up the treadmill takes approximately
50 seconds after stepping onto the belt.
Unit will go into Energy Saving Mode after 5
minutes of inactivity. To wake up the console,
pedal until you hear a beep. The unit will
automatically wake up and the console will light
up. Waking up the unit takes approximately 50
seconds after beginning to pedal.
Check levelers and level treadmill. Check striding
belt & re-tension as necessary. Refer to Elevation
Series 95T Treadmill & PCS Treadmill Discover
SE3, Discover SI, & Explore Assembly Instructions.
Instruct users not to push striding belt in either
direction.
Replace belt and deck. Contact Life Fitness
Customer Support Services.
Plug treadmill into a dedicated 20 amp circuit.
Inspect underneath striding belt and machine.
Remove any debris or objects that may cause
interference with the treadmill.
Check all electrical connections for proper
attachment. Contact Customer Support Services.
Page 78 of 86