Advertisement
Further examples
The "zEn14_02_FM354_EX" or "zEn13_02_FM353_EX" project contains further helpful examples
which you can adapt to your application.
Note
You should activate functions alarm generation, alarm selection and all monitors in normal opera-
tion.
You can set the alarm generation function on index card "Basic Parameters" in dialog "Properties −
FM 354 SERVO − (R0/S4)" or "Properties − FM 353 STEPPER − (R0/S4)" (see also heading "Para-
meterizing the FM 354 or FM 353 module" or Section 5.2 in Manual).
The monitoring functions, e.g. MD20 hardware monitor, MD21/22 software limit switches, etc. are acti-
vated by means of parameter settings.
Make sure that the data are transferred to the FM 354 or FM 353 and the CPU again afterwards.
Diagnostics
Input errors, wiring mistakes or conflicting parameter settings may cause errors which are displayed
by group error LED "SF" on the FM 354 or FM 353.
For a description of how to localize and remedy errors and messages of this type, please refer to Sec-
tion 11 of the Manual.
− 7 −
-7
Advertisement
