Table of Contents
Advertisement
Description of Multi Stack Auto Fill Pass Thu machines
The Multi Stack Auto Fill Pass Thru unit must only be used to keep cooked food hot and
moist; it must not be used to re-heat cooked foods.
The machine is suitable for holding cooked meats and fish.
This unit is more complex machine than a standard Pass-Thru and as such there are a few
more rules of use.
When the machine is placed in the position that it will be used in it is important to
ensure that it is level. Ensure that the surface the Pass-Thru is mounted on is flat
and well supported.
The machine can be either connected to a Mains water supply or the supplied water
tank (which must be refilled by the machine operator).
The unit is supplied as standard with the remote water tank. The water pressure
reducing valve is pre-set, however if the location the machine is being installed in
has a different water pressure this may need to be adjusted.
If the tank is to be re-positioned, OR mains feed is to be made the water feed
connection to the machine must be dis-connected. See Fig. 1 & Fig. 2 below.
Figure 1
The standard plumbing fitting used for a washing machine can be fitted to the
remaining threaded piece shown in Fig 2
The tank can be mounted on the opposite side of the unit if desired, alternatively the
tank can be placed on an up-stand or other location – If this is the case it is
important that the tank is NOT at a lower position than it would be if it were
mounted on the side of the machine, otherwise the water flow will be adversely
affected.
Figure 2
Page 8 of 28
Advertisement
Table of Contents
