Krups XP345 Manual page 34

PROBLEMS
The appliance
work.
The super
nozzle produces little or no
froth.
The super
nozzle does not suck up
any milk.
If it is not possible to identify the cause of a malfunction, please contact an approved
service centre. Never disassemble the appliance. (if the appliance has been
disassembled, the guarantee may no longer be valid).
ELECTRIC OR ELECTRONIC PRODUCT AT END
We participate in the protection of the environment!
Your appliance contains a number of materials that can be reused or recycled.
Take it to a collection point or an approved service centre so that it can be dealt
with appropriately.
31
POSSIBLE CAUSES
doesn't The
deactivated due to a lack
of water.
The removable water tank
has been fitted incorrectly.
cappuccino The
nozzle
installed.
The milk is too warm.
cappuccino
pump has been
super cappuccino
is not properly
OF LIFE
SOLUTIONS
Fill the tank with water
and re-initiate the pump
(see paragraph: USING
FOR THE FIRST TIME).
Avoid emptying the tank
completely.
Position the water tank
correctly.
Check that the accessory
has been
mounted on the appliance:
remove it and then install it
again on the swivel arm by
means of a firm twist from
right to left.
Check that the flexible
hose is not obstructed
or twisted and that is fits
properly into the accessory
to prevent any air intake.
Use a small jug. Use very
fresh, very cold
Follow the milk frothing
instructions (paragraph on
STEAM FUNCTION).
Rinse and clean
accessory (please refer to
the chapter on «Maintenance
and Cleaning»).
properly
milk.
the