Star SP500 Series User Manual page 10

Loading the Paper (Auto Cutter Model)
Cover
E R E R
R O R O
R R
F E F E
E D E D
P O P O
W E W E
R R
Roll paper
Roll paper
Paper feeder
O N O N
F F
O F O F
1 Open the cover.
Important!
1. Do not touch the print head immediately after
printing as it can be extremely hot.
2. Do not touch the cutter blade.
• There is a cutter inside the paper outlet slot.
Not only should you not put your hand in the
paper outlet slot while printing is in progress,
never put your hand into the outlet even when
printing is not in progress.
2 Cut off the front edge of the roll paper
perpendicularly.
3 Confirm that the power of the printer is turned
on.
4 While observing the direction of the roll, set the
paper roll into the hollow as shown in figure.
5 Insert the edge of the paper into the paper feeder
(black plastic part). If inserted correctly, the edge
of the paper will pass through the auto cutter
paper slit. Press the FEED button to cut the
paper.
6 Remove the cut piece of paper and close the
cover.
Note: When the paper end mark appears on the
paper, replace the paper roll before it runs
out.
– 10 –