Advertisement
WARNING!
TURN KEY OFF BEFORE SERVICING.
5
See Figure 6. Open the rear Door (G) and locate the Bracket (H) (part of the frame) where the back-up alarm will mount using the pre-drilled
holes.
6
Remove the (3) Screws (I) that secure the rear Panel (J). Carefully pull off the rear panel, remove the brake light bulbs from the panel by rotating
1/4 turn counterclockwise. Set the panel aside.
7
Mount the back-up alarm to the frame as shown using Screws (D), Washers (F) and Nuts (E).
8
Locate the Wire Connector (K) from the main wiring harness behind where the rear panel was. The connector will have one GRN/BRN and one
ORN wire going to it. Plug in the alarm harness to this connector.
9
Close the rear door. Start the machine and test the back-up alarm for proper operation. Alarm should sound in reverse only. Once it is confi rmed
that the alarm works, reinstall the light bulbs to the rear Panel (J) and secure panel with Screws (I).
FIGURE 6
G
Diesel, LPG, Petrol model shown, Battery models look similar and have same installation.
© 2013 Nilfi sk-Advance, Inc.
Captor / CR 1100, 1200, 1400 INSTALLATION INSTRUCTIONS
H
A
(page 7 of 7)
K
D
F
8/03 revised 7/13 Form No. 56040800 REV D
I
J
FRONT
B
E
Advertisement
