Advertisement
CS7000 PROGRAM CONTROLLER TO RECOGNIZE THIS KIT
1.
See Figure 3
Turn the Key Switch (3A) to the Off position.
2.
Press and hold both Turn Signal buttons
3.
The hidden confi guration menu will appear on the Display Screen
(3H) buttons to scroll through the menus until "Back-up Alarm Installed" appears.
4.
Press the One Touch Scrub button
5.
Press the Scrub Pressure Increase button
6.
Press the One Touch Scrub button
7.
Turn the Key Switch
(3A) to the off position to exit the hidden menus.
FIGURE 3
3B
3A
© 2013 Nilfi sk-Advance, Inc.
(3C and 3D) and turn the key switch On. Continue to hold both buttons for 2 seconds.
(3F) to enter the submenu.
(3E) until "Installed" is shown on the display.
(3F) to save the setting, and then press the Solution On/Off button (3G) to exit the submenu.
3C
(page 3 of 7)
(3B). Use the Scrub Pressure Increase (3E) and Scrub Pressure Decrease
3D
8/03 revised 7/13 Form No. 56040800 REV D
3E
3F
3G
3H
Advertisement
